topic Re: save command in ONTAP Hardware https://community.netapp.com/t5/ONTAP-Hardware/save-command/m-p/58099#M4032 <HTML><HEAD></HEAD><BODY><P>Hi Mark.zhang,</P><P></P><P>The filer reads the /etc/rc on boot up to load the network information. You have to add it there to make any network configurations permanent.</P><P>Have you updated the changes in the /etc/rc??</P><P></P><P>Regards,</P><P>Hari.</P></BODY></HTML> Mon, 10 Mar 2014 11:33:18 GMT HARI_KRISHNA981 2014-03-10T11:33:18Z save command https://community.netapp.com/t5/ONTAP-Hardware/save-command/m-p/58095#M4031 <HTML><HEAD></HEAD><BODY><P>Hi, I tried to login sp and system console to my Netapp FAS3140. I configure my network part. But sometime I found my configuration lost after I logout. </P><P>So my question is if there are some command need to run to save my change? </P><P>Thanks! </P></BODY></HTML> Thu, 05 Jun 2025 05:41:24 GMT https://community.netapp.com/t5/ONTAP-Hardware/save-command/m-p/58095#M4031 mark_zhang 2025-06-05T05:41:24Z Re: save command https://community.netapp.com/t5/ONTAP-Hardware/save-command/m-p/58099#M4032 <HTML><HEAD></HEAD><BODY><P>Hi Mark.zhang,</P><P></P><P>The filer reads the /etc/rc on boot up to load the network information. You have to add it there to make any network configurations permanent.</P><P>Have you updated the changes in the /etc/rc??</P><P></P><P>Regards,</P><P>Hari.</P></BODY></HTML> Mon, 10 Mar 2014 11:33:18 GMT https://community.netapp.com/t5/ONTAP-Hardware/save-command/m-p/58099#M4032 HARI_KRISHNA981 2014-03-10T11:33:18Z