FAS3210 Power down and Power on procedures via SP

RATNATHURAI — Wed, 04 Jun 2025 18:56:11 GMT

I need to shutdown FAS3210 for a day and looking for the steps. I read few posts saying that cf disable and halt will shutdown via ssh.

What are the procedures to shutdown via SP console?

Re: FAS3210 Power down and Power on procedures via SP

SeanHatfield — Tue, 04 Oct 2016 15:51:27 GMT

From the SP, use the "system console" command to connect to the console, then log into ONTAP. From there the process is the same as it would be over ssh.

7-mode (repeat on each controller):

halt -f

cDOT (halts the entire cluster):

halt * -inhibit-takeover true -skip-lif-migration-before-shutdown true -ignore-quorum-warnings true

That should leave the systems at the LOADER prompt. After the maintenance event if its still sitting at the loader:

boot_ontap

Repeat on each node, wait for things to settle, then run config advisor to check for anything unexpected.

topic FAS3210 Power down and Power on procedures via SP in ONTAP Hardware

FAS3210 Power down and Power on procedures via SP

Re: FAS3210 Power down and Power on procedures via SP