topic Re: configuring trunk mode betweenAFF 300 and switch 6513 in AFF

configuring trunk mode betweenAFF 300 and switch 6513

joao2019 — Wed, 04 Jun 2025 11:03:10 GMT

Hi guys
I am trying to configure the trunk mode between a300 storage and Cisco Catalyst switch. and doesn't work

On the storage side, I created:
Ifgrp (two ports) -> vlan () -> Lif
Note: When I create Lif, it doesn't ping

On the side switch, I configured two ports as a trunk mode and stop allowing all vlans to pass
Note: if I configure the two ports on the switch in access mode they work perfectly. Only in trunk mode that does not work.

info:
Storage: AFF 300, ONTAP9.7
Switch: catalyst-6513
someone ?? please

Re: configuring trunk mode betweenAFF 300 and switch 6513

maffo — Wed, 01 Jul 2020 05:12:55 GMT

if you set up VLANs on the controller side, on the trunk ports on the switch you need to allow at least the tags used on the storage side.

Re: configuring trunk mode betweenAFF 300 and switch 6513

joao2019 — Wed, 01 Jul 2020 11:45:58 GMT

In Switch Side:

I configured to allow all tags. unsuccessful
I configured to allow specific tags. unsuccessful

Re: configuring trunk mode betweenAFF 300 and switch 6513

joao2019 — Wed, 01 Jul 2020 21:37:34 GMT

The configuration on the Switch side

Core cisco WS-C6513

interface TenGigabitEthernet1/9/4

description Ligacao NETAPP AFF

switchport

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 1,2,4,16,20,25,40-44,70,71,101,102,220,225,332

channel-protocol lacp

channel-group 100 mode active

interface TenGigabitEthernet2/9/4

description Ligacao NETAPP AFF

switchport

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 1,2,4,16,20,25,40-44,70,71,101,102,220,225,332

channel-protocol lacp

channel-group 100 mode active

Re: configuring trunk mode betweenAFF 300 and switch 6513

Mjizzini — Fri, 10 Jul 2020 08:16:05 GMT

Are the ports going into s - suspended state?

As a test, try to run the command no port-channel standalone-disable on the port-channel interface. You will need to bounce the port-channel interface.