topic Re: Cisco UCS Direct Attached Storage for NFS in FlexPod Discussions

Cisco UCS Direct Attached Storage for NFS

ORONA_MIKEL — Tue, 21 Apr 2015 04:42:30 GMT

We are configurating one Flexpod solution.
UCS 6296UP with Fas8020 Ontap 8.3 Direct Attached Storage for NFS

This is the information found

http://www.cisco.com/c/en/us/products/collateral/servers-unified-computing/ucs-6100-series-fabric-interconnects/whitepaper_c11-702584.html

We are create the "appliance ports" but this are in error.

Error: ENM source pinning failed

Thanks

Re: Cisco UCS Direct Attached Storage for NFS

DREW_RUSSELL — Tue, 21 Apr 2015 05:17:40 GMT

It's going to be hard to troubleshoot with out many details on the configuration. To start with, make sure that the VLAN you have configured on the Appliance port exsits in both the LAN Cloud and Appliance sections.

Re: Cisco UCS Direct Attached Storage for NFS

radek_kubka — Thu, 23 Apr 2015 10:08:27 GMT

Hi,

This blog post describes nicely solving the issue, which quite likely is due to VLAN discrepancies:

http://wahlnetwork.com/2014/09/23/enm-source-pinning-failed/

Regards,

Radek

Re: Cisco UCS Direct Attached Storage for NFS

ORONA_MIKEL — Thu, 23 Apr 2015 19:38:02 GMT

Thanks

I am test with this configuration but the ports are in fail.
is it necesary some special parameters in NetApp (Ontap:8.3)?

I detec what when I configure with "Set Ethernet Swiching Mode" the port are up but in normal mode "End-Host Mode"they are in fail.

Re: Cisco UCS Direct Attached Storage for NFS

DREW_RUSSELL — Thu, 23 Apr 2015 19:44:56 GMT

There shouldn't be any special configuration you'll need on the NetApp side.

Did you test the VLAN issue mentioned?

Re: Cisco UCS Direct Attached Storage for NFS

ORONA_MIKEL — Thu, 23 Apr 2015 19:53:59 GMT

Yes I configure same VLAN in two level and It's not sufficient.

Only changing mode, system reboot but I think this is not good solution.

Thanks

Re: Cisco UCS Direct Attached Storage for NFS

ORONA_MIKEL — Fri, 24 Apr 2015 11:17:41 GMT

This is how it is configured.

UCSM is in 2.1(3e) version and NetApp in 8.3

Thanks

Re: Cisco UCS Direct Attached Storage for NFS

Achim — Tue, 28 Apr 2015 08:30:59 GMT

Hello.

Same issue here. Configured the vlans in both (lan cloud and appliances).

Port is in failed mode:

Overall Status

Failed

Additional Info

ENM source pinning failed

Admin State

Enabled

Re: Cisco UCS Direct Attached Storage for NFS

ORONA_MIKEL — Wed, 06 May 2015 17:30:21 GMT

We view the NetApp interfaces are CNA so we are testing with Fcoe Sotorage port. Is it right this option?

How confirure the vlans?

Thanks

Re: Cisco UCS Direct Attached Storage for NFS

ORONA_MIKEL — Tue, 19 May 2015 08:07:47 GMT

My error was I not had any server created. When I create a server with vNic in this Vlan the port are turn up in "storage port" mode.

Other question, If Netapp port are in ifgroup in Fabric Interconet with port channel?

Thanks

Re: Cisco UCS Direct Attached Storage for NFS

SLASH5K200 — Sun, 29 Nov 2015 00:39:30 GMT

Hi,

Im having the same problem.

Can i confirm that you resolved this by deploying a service profile on a blade that made use of the storage appliance vlan via a vNic Template and that fixed the error ?

Cheers,

Chris

Re: Cisco UCS Direct Attached Storage for NFS

ORONA_MIKEL — Wed, 23 Dec 2015 20:05:00 GMT

Yes this is the solution. The system need link.

Re: Cisco UCS Direct Attached Storage for NFS

KSALINVILLE — Tue, 01 Mar 2016 05:23:35 GMT

I know that this is a mildly dated thread, however, I've just ran into this issue at a client site where we were making a number of modifications to SnapMirror configurations with a direct-attached to UCS setup and the fix was not to add the new NetApp VLAN to a Service Profile vNIC. The fix was to navigate to each of the appliance ports (in our case just one per fabric) and verify that the newly-created Appliance VLAN was actually checkmarked to enable it on the Applianct Ports. It did also have to be in both the Appliance Cloud and the LAN Cloud as a Global VLAN.

Thanks!
Kris

Re: Cisco UCS Direct Attached Storage for NFS

Kishor — Sat, 08 May 2021 10:27:22 GMT

Thanks Chris. In my case the issue was that I didn't create the same VLAN in the LAN cloud but only created in appliance cloud. Hence it failed. Issue got resolved after creating the same VLAN in LAN cloud after referring your solution.