topic Re: PSTK cmdlet to check SP status in Microsoft Virtualization Discussions

PSTK cmdlet to check SP status

netappwala — Wed, 04 Jun 2025 22:30:03 GMT

Hi,

Is there any cmdlet to check and configure SP? At least to check SP status? I am using PSTK 4.0

Thanks,

Charan

Re: PSTK cmdlet to check SP status

asulliva — Wed, 16 Dec 2015 19:59:01 GMT

Hi Charan,

If you're using cDOT you can use the "Get-NcServiceProcessor" cmdlet. There are a number of SP related commands for cDOT...use this command to see them

Get-NcCommand -Category "Service Processor"

Hope that helps!

Andrew

Re: PSTK cmdlet to check SP status

netappwala — Thu, 17 Dec 2015 12:31:58 GMT

Hi Andrew,

No SP cmdlet for 7 mode? I need for 7 mode. Below is the setup we are running.

DOT 7 mode; 8.1; power shell 2.0; PSTK 4.0

Thanks,

Sri Charan

Re: PSTK cmdlet to check SP status

ekashpureff — Thu, 17 Dec 2015 14:40:00 GMT

Sri -

Not that I can find for 7-Mode, only for Cluster ...

I hope this response has been helpful to you.

At your service,

Eugene E. Kashpureff, Sr.
Independent NetApp Consultant http://www.linkedin.com/in/eugenekashpureff
Senior NetApp Instructor, IT Learning Solutions http://sg.itls.asia/netapp
(P.S. I appreciate 'kudos' on any helpful posts.)

Re: PSTK cmdlet to check SP status

netappwala — Thu, 17 Dec 2015 15:43:27 GMT

Sir,

This is really strange that how this important cmdlet has not given by DOT PSTK for 7-Mode. personally I believe that its a SP cmdlet is really improtant.

is there any way to retrieve SP IP address by using other cmdlets?

Thanks,

Charan

Re: PSTK cmdlet to check SP status

asulliva — Thu, 17 Dec 2015 16:45:29 GMT

There is no ZAPI to address the SP/RLM/BMC in 7-mode, so consequentially there is no cmdlet. You could use "Invoke-NaSsh" to execute the command, you'd have to parse out the result though.

Andrew