Disk Limit results differ from get-ncquota and get-ncquotareport

steven_doan — Wed, 04 Jun 2025 13:30:06 GMT

I am trying to have two basic functions: to query a given quota and to modify that same quota.
However, the resulting output does not seem to match

If I run the query command [GET-NCQUOTAREPORT] it returns this value.

QuotaType QuotaTarget Volume Qtree DiskUsed FilesUsed Vserver
--------- ----------- ------ ----- -------- --------- -------
tree /vol/test/test test test 8 3 vserver1

If I query it differently [GET-NCQUOTA] I get this returned:

QuotaType QuotaTarget Volume Qtree DiskLimit FileLimit Vserver
--------- ----------- ------ ----- --------- --------- -------
tree /vol/test/test test 1048576 1048576 - vserver1

If I modify [SET-NCQUOTA] the console output is the following:

QuotaType QuotaTarget Volume Qtree DiskLimit FileLimit Vserver
--------- ----------- ------ ----- --------- --------- -------
tree /vol/test/test test 1048576 - vserver1

QuotaTarget : /vol/test/test

Qtree : test
DiskUsed : 8
DiskLimit : 5120

As you can see the value of disk limit differs between the two. Why is this and how can I adjust the query/modify commands so that it reflects the correct disk limit information which shows correctly when viewing the disk limit in the GUI interface?

topic Disk Limit results differ from get-ncquota and get-ncquotareport in Microsoft Virtualization Discussions

Disk Limit results differ from get-ncquota and get-ncquotareport