https://community.netapp.com/t5/Microsoft-Virtualization-Discussions/How-to-use-Powershell-Toolkit-to-read-boot-variables/m-p/147305#M5985 <P>Trying to figure out how to read node boot variables using PSTK.&nbsp; I ned to perform the equivalent of:</P> <P>&nbsp;</P> <P style="padding-left: 30px;"><STRONG>systemshell -node * kenv kmip.init.interface</STRONG></P> <P>&nbsp;</P> <P>This command is only available in diag mode in the CLI, so I am not sure it can be done thru the API.</P> <P>Any suggestions?</P> Wed, 04 Jun 2025 12:42:56 GMT StevePutre 2025-06-04T12:42:56Z https://community.netapp.com/t5/Microsoft-Virtualization-Discussions/How-to-use-Powershell-Toolkit-to-read-boot-variables/m-p/147305#M5985 <P>Trying to figure out how to read node boot variables using PSTK.&nbsp; I ned to perform the equivalent of:</P> <P>&nbsp;</P> <P style="padding-left: 30px;"><STRONG>systemshell -node * kenv kmip.init.interface</STRONG></P> <P>&nbsp;</P> <P>This command is only available in diag mode in the CLI, so I am not sure it can be done thru the API.</P> <P>Any suggestions?</P> Wed, 04 Jun 2025 12:42:56 GMT https://community.netapp.com/t5/Microsoft-Virtualization-Discussions/How-to-use-Powershell-Toolkit-to-read-boot-variables/m-p/147305#M5985 StevePutre 2025-06-04T12:42:56Z https://community.netapp.com/t5/Microsoft-Virtualization-Discussions/How-to-use-Powershell-Toolkit-to-read-boot-variables/m-p/147306#M5986 <P>You are going to have to do something like this</P> <P>&nbsp;</P> <P>invoke-ncssh 'set diag -c off;systemshell -node * kenv&nbsp; kmip.init.interface'</P> <P>&nbsp;</P> <P>My cluster isn't returning anything</P> Tue, 19 Mar 2019 18:21:13 GMT https://community.netapp.com/t5/Microsoft-Virtualization-Discussions/How-to-use-Powershell-Toolkit-to-read-boot-variables/m-p/147306#M5986 JGPSHNTAP 2019-03-19T18:21:13Z