topic Re: Trying to access ETC$ as CIFS shares to Copy Ontap Upgrade Image in Network and Storage Protocols

Trying to access ETC$ as CIFS shares to Copy Ontap Upgrade Image

NAYABSK — Thu, 05 Jun 2025 04:36:11 GMT

Hi All,

I am planning to upgrade my Ontap to 8.1.4 and i have downloaded the ONTAP IMAGE and i have shared ETC$ following this link :- http://www.cosonok.com/2013/09/how-to-access-etc-share-from-windows.html but i was able to map the share as drive and able to see contents in /ETC but when i tried opening the folder /etc/software it is throwing an error stating not enuff permissions 😞

Also one more doubt i know the Ontap Image itself will have DISK SHELF FIRMWARE , Will that also have the disk qualification packages ???? Or do i need to download the disk qualification packages seperately and upgrade them ????

Thanks,

Nayab

Re: Trying to access ETC$ as CIFS shares to Copy Ontap Upgrade Image

NAYABSK — Mon, 13 Apr 2015 02:06:02 GMT

Hi All,

I have found the solution for this and solution is to create same user in Windows as well as in Netapp also password must be same

Example ( SAME SHOULD BE BOTH IN WINDOWS AND NETAPP )

USER:- storageadmin

PASSWORD :- P@ssw0rd

Please refer to this link for more information :- https://kb.netapp.com/support/index?page=content&id=1011622&locale=en_US

Thanks,

Nayab

Re: Trying to access ETC$ as CIFS shares to Copy Ontap Upgrade Image

NAYABSK — Tue, 14 Apr 2015 06:30:59 GMT

Also to apply the permissions to all the sub-directories of that particular share run the command

cifs access <share> -m

Re: Trying to access ETC$ as CIFS shares to Copy Ontap Upgrade Image

RPHELANIN — Tue, 14 Apr 2015 09:59:58 GMT

you will need to download hte disk qual package seperately and copy it to the filer.

Also did you run upgrade advisor as you may have disks that need their firmware upgraded prior to the ontap image upgrade

Face a problem to open cluster share folder

MRADULSINGH — Thu, 07 May 2015 10:32:59 GMT

hi nayab,

i am face a problem with cluster mode 8.2.1 in open share folders. can you please tell me what ip use for open share folder . i make a cluser with two nodes and make a one svm and configure this svm with two network interface succersfully . if i opened share folder using both network interface ip then share folder open successfully . but when i open share folder using cluster or node ip share can not be opened.please tell me if you know what is the concept of share in cluster mode.

Regards

Govind Sharma