topic Re: There are not enough spare disks ... Please add spare disks warning message in Active IQ Unified Manager Discussions

There are not enough spare disks ... Please add spare disks warning message

NETAPP_TROV — Thu, 05 Jun 2025 06:44:15 GMT

Hello,

I have problem with the following message:

There are not enough spare disks. /aggr0/plex0/rg1: Please add spare disks supporting block checksums with minimum size: Used: 136000/278528000 (MB/blks)

I found 2 faulty HDDs (136 GB/15k rpm).

After plugging two new HDDs (274 GB/15k rpm) the disks looks fine and ready but the above warning message did not disappear.

There are screenshots and logs attached.

Please help,

Thanks in advance.

Re: There are not enough spare disks ... Please add spare disks warning message

paulstringfellow — Thu, 06 Oct 2011 10:41:55 GMT

Have they been assigned to the controller yet? Are they showing as spares? Or as unowned?

Re: There are not enough spare disks ... Please add spare disks warning message

NETAPP_TROV — Fri, 07 Oct 2011 05:16:56 GMT

Hi,

thanks for you reply.

As shown in the attached trace (Filers.zip), they are shown as spare.

Re: There are not enough spare disks ... Please add spare disks warning message

jonathon_lanzon — Fri, 07 Oct 2011 08:34:17 GMT

Filer1 is okay. The problem is filer2.

From your attachment I can aggr0 on filer2 is made up of 144GB 15k FC disks.

There are two spare disks on filer2, both are 300GB 10k FC drives.

Because the drives are 10k they won't be substituted with a 144GB 15k drive in case of failure.

However I believe these drives are 15k drives (Hitachi Viper-C 300 GB 15k RPM FC) but the system is only seeing them as 10k drives. You may need to upgrade the disk firmware to NA02 for the controller to recognise them as 15k drives.

Once you update the firmware and the system recognises them as 15k drives the low spare warning will go away.

Re: There are not enough spare disks ... Please add spare disks warning message

NETAPP_TROV — Fri, 07 Oct 2011 09:45:52 GMT

Hi Jonathon,

thank you very much for answer 🙂

Can you please tell me how to upgrade disk firmware to NA02 for the controller?

Is there some how-to manual?

Re: There are not enough spare disks ... Please add spare disks warning message

jonathon_lanzon — Mon, 10 Oct 2011 02:10:20 GMT

Go to NOW and then to the Disk Firmware section in the Download menu.

The direct link is https://now.netapp.com/cgi-bin/diskfwmustread.cgi/download/tools/diskfw/bin/all

Howerver you may just need to update the disk qualification packages found here https://now.netapp.com/download/tools/diskqual/. I recommend doing this first.

Re: There are not enough spare disks ... Please add spare disks warning message

NETAPP_TROV — Wed, 12 Oct 2011 16:34:16 GMT

Hi Jonathon,

thank you very much, I will do like you proposed