topic Management Console shows the Peformance Data only for one Week in Active IQ Unified Manager Discussions

Management Console shows the Peformance Data only for one Week

FLISCHEIDBRACHT — Thu, 05 Jun 2025 06:14:26 GMT

where in the DFM option can i change this setting?

I can't find the option.

DFM 5.1

Re: Management Console shows the Peformance Data only for one Week

adaikkap — Mon, 03 Dec 2012 10:24:18 GMT

Hi,

In what mode is your DFM 5.1 running ? 7-Mode or Cluster-Mode ? If cluster- mode you dont have a way to change your retention setting. If its 7-Mode refer to section 14 14 Data Collection. In the following TR.

http://media.netapp.com/documents/tr-4090.pdf

Regards

adai

Re: Management Console shows the Peformance Data only for one Week

LTDCLSERGAO — Mon, 03 Dec 2012 10:35:46 GMT

hello,

# dfm perf data list ( this shows collection perdiod ( secs))

to change Performance Data Retention Times for "iSCSI Basic" ( for exemple) :

# dfm perf data modify "iSCSI Basic" collectionPeriod=7776000

--> ======== In oncommand Core Package

# dfm perf data modify -G iscsi -o <hostname> -r 90d

Re: Management Console shows the Peformance Data only for one Week

adaikkap — Mon, 03 Dec 2012 10:42:49 GMT

Hi Said,

You still haven't answered my question. For DFM operating in Cluster-Mode flexbile data collection is not supported unlike the one in 7-Mode, which can be done as shown in the TR section 14.

Regards

adai

Re: Management Console shows the Peformance Data only for one Week

LTDCLSERGAO — Mon, 03 Dec 2012 10:47:31 GMT

Hi Adai,

ok, I have not experience with the cluster mode yet. thank you for the information.

Regards,

Said

Re: Management Console shows the Peformance Data only for one Week

FLISCHEIDBRACHT — Mon, 03 Dec 2012 12:13:41 GMT

Thank you, when i type dfm perf data list/modify i get the information i am looking for.

I run DFM in 7 Mode.

Is there an option to set defaults, also for new filer?

Re: Management Console shows the Peformance Data only for one Week

adaikkap — Mon, 03 Dec 2012 12:18:09 GMT

Hi,

Unfortunately, there is no cli to modify the retention settings. Instead you will have to use the NMC UI as described in the TR. Also find the link to a previous thread where the same is discussed.

https://communities.netapp.com/message/52514#52514

Regards

adai