topic Re: Volume offline workflow in Active IQ Unified Manager Discussions

Volume offline workflow

filer_sith — Tue, 26 May 2015 09:11:22 GMT

May I know if there if anyone already tried to create a workflow that just offline a volume?

thanks.

Re: Volume offline workflow

sinhaa — Tue, 26 May 2015 10:55:49 GMT

The below command code will do for you.

##Begin Code

param (
[parameter(Mandatory=$true, HelpMessage="Cluster IP address")]
[string]$Cluster,

[parameter(Mandatory=$true, HelpMessage="Volume name")]
[string]$VolumeName,

[parameter(Mandatory=$true, HelpMessage="Storage Virtual Machine name")]
[string]$VserverName
)

Connect-WfaCluster $Cluster -Vserver $VserverName
Set-NcVol -Name $VolumeName -Offline

##End code

sinhaa

Re: Volume offline workflow

geringer — Tue, 26 May 2015 14:38:55 GMT

Sinhaa,

For Clustered Data OnTap, we may need to un-mount the volume before we take it off-line.

Filer-sith,

I have a remove volume workflow that, un-mounts the volume, takes it offline, and sends an email to notify WFA Admins that a volume deletion is requested. The workflow has an approval point after the email, and once approved it can remove the volume. My lab is down at the moment, but if this workflow would help you, I can clean I up and post it.

Mike

Re: Volume offline workflow

sinhaa — Tue, 26 May 2015 16:43:29 GMT

Right Mike. Added the line to Un-mount the volume.

##Begin Code

param (
[parameter(Mandatory=$true, HelpMessage="Cluster IP address")]
[string]$Cluster,

[parameter(Mandatory=$true, HelpMessage="Volume name")]
[string]$VolumeName,

[parameter(Mandatory=$true, HelpMessage="Storage Virtual Machine name")]
[string]$VserverName
)

Connect-WfaCluster $Cluster -Vserver $VserverName

Dismount-NcVol -Name $VolumeName
Set-NcVol -Name $VolumeName -Offline

##End code

Re: Volume offline workflow

junec — Thu, 25 Jun 2015 08:18:41 GMT

How about for 7-Mode only? And if it possible, can put it in .dar file compatible with WFA 2.2. Thank you so much

Re: Volume offline workflow

justin_smith — Tue, 06 Oct 2015 19:54:54 GMT

Im creating a new command since this isnt a standard one.

Whats the string representation field?