topic Re: Can't Join second node into 8.2.3 simulate cluster in Simulator Discussions

Can't Join second node into 8.2.3 simulate cluster

Shivang — Wed, 04 Jun 2025 18:05:50 GMT

I want to create 8.2.3 multinode cluster simulator, in which I am able to create a single node without changing default serial number. Then I have started to create a second node but in which we have to change serial number (defined in license.txt) but after that I am not able to join this node into cluster.

Is there any document available for specific to this version (8.2.3)?

Re: Can't Join second node into 8.2.3 simulate cluster

ekashpureff — Tue, 13 Dec 2016 14:37:24 GMT

Shivang -

I didn't find a link for the 8.2.3 Setuo Guide, but it shouldn't be any different from other versions.

(I still have a copy of the 8.2.1 Setup guide, but didn't want to post it.)

You need to change the nvram.sysid as well as the serial number of the second node:

10. Change the Serial Number and System ID for this node:
VLOADER> setenv SYS_SERIAL_NUM 4034389-06-2
VLOADER> setenv bootarg.nvram.sysid 4034389062
11. Verify that the information was saved correctly by entering the following two commands:
VLOADER> printenv SYS_SERIAL_NUM
VLOADER> printenv bootarg.nvram.sysid

I hope this response has been helpful to you.

At your service,

Eugene E. Kashpureff, Sr.
Independent NetApp Consultant http://www.linkedin.com/in/eugenekashpureff
Senior NetApp Instructor, FastLane US http://www.fastlaneus.com/
(P.S. I appreciate 'kudos' on any helpful posts.)

Re: Can't Join second node into 8.2.3 simulate cluster

wh_slayer — Tue, 13 Dec 2016 16:50:39 GMT

What error do you receive when trying to join the cluster?

Re: Can't Join second node into 8.2.3 simulate cluster

Shivang — Wed, 14 Dec 2016 05:43:47 GMT

I have already changed these both parameters for second node but after that It should ask for this option:

Do you want to create a new cluster or join an existing cluster?

for joining we have to choose "join" but it is not asking for this option

Re: Can't Join second node into 8.2.3 simulate cluster

SeanHatfield — Wed, 14 Dec 2016 07:33:53 GMT

8.2.3 should boot into cluster setup after doing the option 4 install. If you are not getting that, it might be helpful to know what you are seeing, or which prompt you are getting.

For example, if you're at the loader:

VLOADER>

The you need to boot_ontap

If you're getting a login prompt:

login:

Then try admin with no password

then run 'cluster setup'

If you're getting a bootloop, then press ctrl-c when prompted and do an option 4 install.

A few other cases might be solved by just creating a new VM from the original tgz archive.

Re: Can't Join second node into 8.2.3 simulate cluster

Shivang — Thu, 15 Dec 2016 07:32:36 GMT

We are deploying this node on ESXI6.0, Is this reason for not joining?

Re: Can't Join second node into 8.2.3 simulate cluster

SeanHatfield — Thu, 15 Dec 2016 07:37:53 GMT

I have a bunch of them running on esxi6, so probably not.

But, check that both network adapter 0 and 1 are on the same vswitch and portgroup. For testing you can create a local vswitch and connect them up there.