https://community.netapp.com/t5/Simulator-Discussions/Running-9-2RC1-in-a-simulator/m-p/130993#M2144 <P>While we wait for the official 9.2 simulator to be posted to the tool chest, if you want to run 9.2RC1 in a vsim you may need to adjust a setting or two to get the workstation version to boot.</P><P>&nbsp;</P><P>On the workstation version, 5gb of ram doesn't seem to be enough. &nbsp;Adding an additional 128mb or 256mb to the VM should allow it to boot. &nbsp;Alternatively, you can keep it at 5gb if you move the pci hole by adding this line to the virtual machine's .vmx file:</P><PRE>pciHole.start = "1024"</PRE><P>The ESX version defaults to 8gb of ram, so that build&nbsp;should run 9.2RC1 as-is.</P><P>&nbsp;</P> Wed, 04 Jun 2025 15:05:44 GMT SeanHatfield 2025-06-04T15:05:44Z https://community.netapp.com/t5/Simulator-Discussions/Running-9-2RC1-in-a-simulator/m-p/130993#M2144 <P>While we wait for the official 9.2 simulator to be posted to the tool chest, if you want to run 9.2RC1 in a vsim you may need to adjust a setting or two to get the workstation version to boot.</P><P>&nbsp;</P><P>On the workstation version, 5gb of ram doesn't seem to be enough. &nbsp;Adding an additional 128mb or 256mb to the VM should allow it to boot. &nbsp;Alternatively, you can keep it at 5gb if you move the pci hole by adding this line to the virtual machine's .vmx file:</P><PRE>pciHole.start = "1024"</PRE><P>The ESX version defaults to 8gb of ram, so that build&nbsp;should run 9.2RC1 as-is.</P><P>&nbsp;</P> Wed, 04 Jun 2025 15:05:44 GMT https://community.netapp.com/t5/Simulator-Discussions/Running-9-2RC1-in-a-simulator/m-p/130993#M2144 SeanHatfield 2025-06-04T15:05:44Z