https://community.netapp.com/t5/VMware-Solutions-Discussions/NetApp-Flexclone-iSCSI-vSphere-Issue/m-p/113816#M8417 <P>This could be a LUN resignature issue. &nbsp;You might want to check <A href="https://kb.netapp.com/support/index?page=content&amp;id=3011208" target="_self">this KB article</A> to see if it helps.</P><P>&nbsp;</P><P>Andrew</P> Wed, 16 Dec 2015 15:59:59 GMT asulliva 2015-12-16T15:59:59Z https://community.netapp.com/t5/VMware-Solutions-Discussions/NetApp-Flexclone-iSCSI-vSphere-Issue/m-p/113125#M8397 <P><SPAN>I created a flexclone of our snapmirror destination iSCSI&nbsp;volume. I added it the initiator group so all the hosts can see the new flexclone datastore but when I go to add the storage to the hosts it shows up only on the 1st host I add it to. When I try to add it to the other hosts it never actually shows up in the datastore list. I can see the lun and the add storage&nbsp;wizard completes without error but the flexclone never shows up on the remaining hosts. Am I missing something? Running 8.2.3 (7-Mode)</SPAN></P> Wed, 04 Jun 2025 22:38:44 GMT https://community.netapp.com/t5/VMware-Solutions-Discussions/NetApp-Flexclone-iSCSI-vSphere-Issue/m-p/113125#M8397 rbmadison 2025-06-04T22:38:44Z https://community.netapp.com/t5/VMware-Solutions-Discussions/NetApp-Flexclone-iSCSI-vSphere-Issue/m-p/113816#M8417 <P>This could be a LUN resignature issue. &nbsp;You might want to check <A href="https://kb.netapp.com/support/index?page=content&amp;id=3011208" target="_self">this KB article</A> to see if it helps.</P><P>&nbsp;</P><P>Andrew</P> Wed, 16 Dec 2015 15:59:59 GMT https://community.netapp.com/t5/VMware-Solutions-Discussions/NetApp-Flexclone-iSCSI-vSphere-Issue/m-p/113816#M8417 asulliva 2015-12-16T15:59:59Z