AFF, NVMe, EF-Series, and SolidFire Discussions

Highlighted

AFF220 MCC IP 9.7

Hi Guys,

 

I got no Pool 1 Disk on the MCC iSCSI Disk. Automatically assigned works but no Pool 1 Disks.

 

36 Disks; all are partitioned after MCC connection connect we have 216..

6 REPLIES 6
Highlighted

Re: AFF220 MCC IP 9.7

Hi there!

 

If I understand correctly, you are setting up the system from scratch? The system has never been used?

 

First thing I would do is run "set-defaults" at the LOADER prompt, then boot to maintenance mode, and then run "ha-config show" to verify both nodes show as "mccip". Once that is confirmed, boot again and choose option 9a, then let the system reinitialise and start from that point.

 

Let us know how you get on?

Highlighted

Re: AFF220 MCC IP 9.7

Hi Alex,

 

already done, it’s not the first System. The automatically iSCSI Disk creation/assigned has a problem, because I get the Disk but the Disks are not assigned to Pool 1.. 

Highlighted

Re: AFF220 MCC IP 9.7

Hi there,

 

Thanks for that confirmation. Can you also confirm that you have the correct and identical switch RCF file in place?

 

Thanks!

Highlighted

Re: AFF220 MCC IP 9.7

Hi Alex,

 

yes they are correct. MetroCluster interface are successfully created and can ping each other (interface check command). 

Re: AFF220 MCC IP 9.7

Ok, unfortunately I think it will be necessary to open a case with our support team, it sounds like you've done everything right (especially since you mention you have several other successful installs complete)

 

Best regards and you are welcome to send me the case number or post the number here, as I am interested in the root cause.

Highlighted

Re: AFF220 MCC IP 9.7

Solution is to assign the Disk and the Partition manually, because any auto assigned function won't work with a half Shelf...

Try the NEW Knowledgebase!
NetApp KB Site
Forums