I have my configuration on an HA mode, and the interface e0M on each controller, that is the interface that I want to change the IP address.
How can I backup config files on command prompt?, any bash interpreter that I can install into it?, how can I see the content of files and how can I change from one directory to other?.
If its only the e0M IP you need to change it via command line or oncommand system manager.
The e0M management port and RLM/SP/BMC network port are connected to an internal switch on the controller. One port from the switch is wired to the wrench RJ45. With this configuration, both of these management ports need to be on the same subnet.