Subscribe
infonet
Accepted Solution

expresspod, fas2240a, C220, how to delay boot on servers

‎2014-10-20 01:21 PM

Hello,

it is probably questions for Cisco forum but I rarely go there. I have customer where they often lose power, ups drains out and after power is back, things are turned on. Netapp boots later then C220 so you know problem. 

 

Is there a way on UCS to delay boot of OS or hypervisor for certain number of minutes in order to wait for FAS2240 to boot up?

 

Thanks,

Damir

0 Kudos
rarvind
NetApp

Re: expresspod, fas2240a, C220, how to delay boot on servers

‎2014-10-25 10:42 PM

Hello Damir,

 

You will be able to configure a Power Restore Policy using the Cisco Integrated Management Controller.

 

Browse to the below URL and please look for "Configuring the Power Restore Policy" -

 

http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/sw/gui/config/guide/2-0/b_Cisco_UCS_C-series_GUI_Configuration_Guide_201/b_Cisco_UCS_C-se...

 

You can induce a delay of upto 240 seconds before the sever is powered on.

 

Thanks

Arvind.