Hey there, sorry for hijacking this thread, but in our tests this is not working, either with SC 4.1 nor with SC 4.3
When I define one SECONDARY_INTERFACE it works fine.
However, as soon as I define multiple ones, it only uses the last defined one and doesn't see the other destinations anymore.
No matter which syntax I tried, it only works when I only define a single one.
Next thing is: If I have defined a global config, the SECONDARY_INTERFACES parameter in the single backup configs is ignored, it pulls it from the global config, no matter what. If no SECONDARY_INTERFACES are configured in the global config, it stays empty, even if defined in the single config, too 😞
EDIT: also the following does not work when having configured a secondary interface.
PRIMARY:/vol/src/- to PRIMARY:/vol/dst/dst
When the SECONDARY_INTERFACES parameter is set, SC seems to expect the destination to be the name defined there for all relationships.
So when source and destination volume are on the same filer it fails because this one is ignored as the destination name (which is the source name) doesn't match the one configured in the parameter. Which again is bad when combined with global configs, so we would need to configure credentials again in each job which defeats the purpose of global configs.