Data Backup and Recovery

NetApp ApplianceWatch Management Pack SCOM Array Error

superga1999
4,325 Views

Hi,

I have followed the instructions to install the NetApp ApplianceWatch Management Pack for SCOM

Installed MSI on the RMS server (2007 R2 Cu2)

Discovered SNMP network devices of 2 NetApp appliances

Installed MP's (not Pro as no SCVMM available)

When I try to run the task to enter the appliance credentials (set using NetApps BP) there are no appliances and the option is greyed out.

If I try to add an appliance I see the error "Failed to compare two elements in the array"

If I continue and add the controller details it returns a "Object not set to an instance on an object"

So then I enabled the discovery rule for a group containing the appliances...same error

Any assistance with this issue would be appreciated.

Regards,

Gary Tower

6 REPLIES 6

kapildham
4,325 Views

Team, same error here too. Anyone has any luck in resolving this type of errors?

kapildham
4,325 Views

Team, same error here too. Anyone has any luck in resolving this type of errors?

kapildham
4,325 Views

Team, same error here too. Anyone has any luck in resolving this type of errors?

GWNOYES63
4,325 Views

I know this thread is not about oncommand, but was wondering if the SCOM management pack only works if you are using Hyper V or can you use this same app if your virtualiztion platform is VMware?

ramdass
4,325 Views

Sorry for the late response on this. This issue is a known issue that has shown up in some configs but has been addressed in a later version of the management pack software - OnCommand Plugin for Microsoft 3.0 is the product.

Thanks,

Dennis

superga1999
4,325 Views

Thanks for your reply Dennis, we'll give that a try.

Regards,

Gary

Public