Data Backup and Recovery

Snap Creator to create crash consistent snapshots across different controllers

ana_sgr_1985
10,931 Views

Greetings,

I am new to Snap Creator so please pardon may ignorance.

I am looking to take crash-consistent snapshots for multiple volumes across different controllers which may be assigned to ESX nodes or VM. Does NetApp snapcreator has the capability to create consistency groups which may span across separate controller and take crash-consistent snapshots on them. If yes, what are the supported platforms?

Thanks

Anand

6 REPLIES 6

steiner
10,926 Views

SnapCreator will take CG snapshots across as many controllers as you configure. It sets up the write fencing one by one, which might seem odd at first unless you look very closely at how it works. The end result is that all dependent write order is preserved. I’ve personally done snapshots across up to 6 controllers as far back as 6 years ago. Never had a problem…

ktenzer
10,926 Views

Hi Anand,

You can take consistency group snapshots with SC but the consistency groups are per controller, so you get one for each controller. It is a two phased process 1) cg start 2) cg commit.

SC uses following process assuming controller1:vol1,vol2 controller2:vol3,vol4

1) cg start controller1:vol1,vol2

2) cg start controller2: vol1, vol2

3) cg commit controller1:vol1,vol2

4) cg commit controller2:vol3,vol4

While all volumes are fenced via the cg start everything is consistent. However the commit where fencing is removed and snapshot taken is not guaranteed to happen at same time for both controllers and thus consistency cannot be guaranteed unless the application using the storage issues write dependent writes. Most if not all databases do this for example. This means if first write is not acked then another write wont be sent. If this is the case the combination of that plus the CG mechanisms ONTAP provides guarantees consistency. If this isnt the case you need to get application consistency.

Unfortunately I cant give you a yes or a no but hopefully this helps you drive toward a solution

Regards,

Keith

steiner
10,924 Views

What’s the application? The only app I know where CG snapshot might not work is Teradata and it’s possible to configure reiserfs in a really dangerous way. For mainstream filesystems and applications, no problem. If the SC operation completed, your snapshots are valid.

ana_sgr_1985
10,924 Views

Application is Delphix which is Database Virtualization Engine running on VM.

Thanks

Anand Sengar

steiner
10,922 Views

You’ll have to test this. Delphix is effectively a filesystem. I would be surprised if it had problems.

Could I ask why you want to make snapshots? Is this to create backups of databases running under Delphix control?

ana_sgr_1985
10,922 Views

Thanks Keith and Steiner.. guess I will have to test this to know better.

This is to make sure we have point in time backup copy available of the Delphix dSource in case of logical physical corruption. Because if there is corruption on dSource, you basically loose all your vDBs.

-Anand

Public