Data Backup and Recovery

SnapManager for Exchange on VMware

HAZNETAPP
5,403 Views

Hi All,

Can you help me with a best practice disk config.

We are running a virtual Exchange 2010 environment on VMware vSphere 5.0. 

I understand SnapManager for exchange requires RDM's as opposed to VMDK's.  Can you confirm which compatibility mode is required, Physical or Virtual, I have assumed and used Physical??

Also, I have created the Luns on the Netapp rather than via SnapDrive, is this correct?

Thanks

Alex

1 ACCEPTED SOLUTION

HAZNETAPP
5,403 Views

Thank you for your response.

I have set SME up now and all is working as expected.

I have used Physical RDM's.  For reference virtual mode RDM's are not supported.

View solution in original post

3 REPLIES 3

radek_kubka
5,403 Views

Hi Alex,

You should always create LUNs using SnapDrive - unless there are no plans to install it, but this would exclude SME, too.

You can't use VMDKs for Exchange, but you still have two choices:

1) RDMs - it used to be the case that SnapDrive only supported physical mode, not sure if that's still the case, but definitely physical is a safe bet

2) in-guest iSCSI initiator - could be useful if there are plenty of LUNs on the same ESX cluster, this way you avoid hitting the per cluster LUN count limit, as all traffic bypasses ESX stack.

Regards,

Radek

HONGWEIWANG
5,403 Views

I'm working on a virtualization project.  Ms Exchange2010, Vmware ESXi5.1.

I use RDM(physical) for VM,and in test environment, SDR can still use in VM(ESXi server in a MPIO architecture).

HAZNETAPP
5,404 Views

Thank you for your response.

I have set SME up now and all is working as expected.

I have used Physical RDM's.  For reference virtual mode RDM's are not supported.

Public