Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
have installed active passive MS cluster, and SQL 2008 on it. On both nodes installed snapmanager and snapdrive utility. however the snapmanager can only connect to the cluster adress fron one node, when a failover is performed where node 2 is owner, the snapmanager
error message attached, any clue?
3 REPLIES 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Having the same issue, did you resolve it?
Adam
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
This has been resolved way back ago; If I remember it correctly it has something to due with setting. My advice is to check all setting twice and make sure that Snapmanager and snapdrive service is started on both servers (assume that you also run active-passive ms cluster)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Seems that SnapManager has to run under the same account SnapDrive, even though the documentation says they can run under different accounts.
Once I set them both to use the same service account it allowed me to connect.
Adam