Data Infrastructure Management Software Articles and Resources

Day-0 Workflow Example - Install / Update OnTap software

bdave
views-count 1758 Views

Uses 'software update' to install or update software.  Uses a Linux "Jump host" to copy software images to /etc/software on the controller.  Also disables HA cluster failover monitoring ('cf disable'), reboots after software installation, waits until controller is back up again, and re-enables cluster failover monitoring.

This is an example workflow that demonstrates how one might do software installs / upgrades as part of an initial automated configuration deployment.  (I will tie these commands into a much larger workflow before it's over.)

Comments and suggestions welcome!

Thanks,

Dave

Please Note:

All content posted on the NetApp Community is publicly searchable and viewable. Participation in the NetApp Community is voluntary.

In accordance with our Code of Conduct and Community Terms of Use, DO NOT post or attach the following:

  • Software files (compressed or uncompressed)
  • Files that require an End User License Agreement (EULA)
  • Confidential information
  • Personal data you do not want publicly available
  • Another’s personally identifiable information (PII)
  • Copyrighted materials without the permission of the copyright owner

Continued non-compliance may result in NetApp Community account restrictions or termination.

All Community Forums
Public