Active IQ Unified Manager Discussions

Cannot identify resource being over-utilized

Silverfuel
2,896 Views

We get alerts almost every night about Node Resources Over-Utilized and then about 10 minutes later the obselete email as well. But the alert doesn't specify what node resource was over-utilized. Was it CPU, MEM, DISK or some networking counter? The event details doesn't really show much either. Any idea how I can identify what resource is being over-utilized?

 

This is what it looks like:

 

Subject: Alert from OnCommand Unified Manager: Node Resources Over-utilized Warning Threshold Breached (State: New)

 

 

A risk was generated by localhost that requires your attention.

 

Risk          - Node Resources Over-utilized Warning Threshold Breached

Impact Area   - Performance

Severity      - Warning

State         - New

Source        - node name

Trigger Condition - Utilization value of 97% on node name has triggered a WARNING event based on threshold setting of 85%.

Description   - All Warning Alerts

 

Event details:

https://localhost:443/#/events/81

 

Source details:

https://localhost:443/#/nodes/670

 

Alert details:

https://localhost:443/#/alerting/5

 

 

Do not reply to this email. This is an automatically generated email and replies to this email address are not attended to.

 

1 ACCEPTED SOLUTION

GidonMarcus
2,870 Views

Hi.

 

the event you pasted is what the On Command perf passes to On Command Unified, and that's why it's lacking...

 

if you click on the event you will see a description like "Description:     Perf. Capacity Used value of 109% on NODE1 has triggered a WARNING event to identify potential performance problems in the data processing unit."

 

In case of the alert i published. it's driven from configuration i have in "configuration">"performance thresholds" but there are some that are built in and not configurable 😞

 

Gidi

 

Gidi Marcus (Linkedin) - Storage and Microsoft technologies consultant - Hydro IT LTD - UK

View solution in original post

1 REPLY 1

GidonMarcus
2,871 Views

Hi.

 

the event you pasted is what the On Command perf passes to On Command Unified, and that's why it's lacking...

 

if you click on the event you will see a description like "Description:     Perf. Capacity Used value of 109% on NODE1 has triggered a WARNING event to identify potential performance problems in the data processing unit."

 

In case of the alert i published. it's driven from configuration i have in "configuration">"performance thresholds" but there are some that are built in and not configurable 😞

 

Gidi

 

Gidi Marcus (Linkedin) - Storage and Microsoft technologies consultant - Hydro IT LTD - UK
Public