Connecting a FAS2240-2 with 24 internal disks (IOM6), two 2246 shelves (IOM6), and a 4243 (IOM3) SATA shelf. Is it possible to connect all shelves to ports 0a,0b on the controller in the same loop for MPHA or do we need to connect the 2246 shelves to port 0a, since the internal disks are on 0a also, and connect the 4243 shelf to 0b because it is IOM3. We don't want the IOM6 modules to step down to 3G. We would like to have MPHA if possible.
Also note that WireGuage complains and fails when we mix the shelves on the ports or put the 4243 shelf on port 0a because the internal disks are on 0a. In fact, the controller disables the 4243 shelf when we connect it to port 0a. See attached jpg.
Wire-gauge still prompts if both systems are on the same stack, So in answer to this I don't think they can be mixed all DS2246 shelves connected on one stack and the rest on the other this might leave you with a single "pathed" disk configuration
I thought Wiregauge has been discontinued & replaced with Config Advisor?
From my perspective, intermixing SAS shelves has been one of the most annoying & greyest areas over the past two years - a truly moving target with conflicting messages from different resources.
This is what I just discovered in the latest Storage Subsystem FAQ:
CAN DS2246, DS4246 AND DS4243 BE MIXED IN THE SAME STACK?
DS224, DS4246 & DS4243 can be mixed into the same stack. However, when going from IOM3 to IOM6, you can’t have more than one transition.
The wording was far more ambiguous in previous versions of this document though (something like "more than one cross-over point is supported, but not recommended")
This isn't brilliant news for many existing customers, as DS4243 SAS shelves are EOL - so you need DS2246 for more SAS disks, full stop. Then adding SATA disks to the same stack may prove impossible...
Config advisor is a good guideline but there are many other checks that should...need to be done. Checking failover groups for example, network, testing storage failover on the system, lif migration (do all interfaces work...lit up isn't always the best test).