Based on your comment "disabled" I am assuming that you cannot make changes to the network interfaces using version 2.0.2 correct? I installed it and all the commands are greyed out and I can't find a single document on why. Or do I have to run the network configuration checker first then its available?
For 2.0.2 we have disabled the functionality and we will be bringing this back in future releases. The release notes documents the issues. Network configuration checker can be run to figure out if there are any corruptions or other issues.
Thank you for the fast response. I would hope that this would be back very quickly so small IT shops like mine can make changes without needing to learn how to modify the /etc/rc file using command lines.
Just two cents from a guy who has learned to love (well at least like) editing the RC directly and not working with gui's... I would try to learn to be somewhat comfortable with it. Have run into many an issue with SM but when we do it ourselves things seem to go a lot better.
Not in case of NetApp. If it were possible to perform all configuration using CLI, it would be fine. But unfortunately you have weird mix of commands and direct file editing. And direct file editing without front end to check for errors is always bad. It is just so error prone. And you need access to files. When you are facing system having only notebook and crossover cable, you often do not even have possibility to access files.
Not to mention that NetApp CLI is stone age. Really. Yes, after ten years you get to use it, but we are speaking about customers who have other tasks than learning it.
Show me consistent CLI with completion support and ability to make persistent configuration changes everywhere and I will wholeheartedly agree with you.