2018-05-16 01:26 AM
We have a netapp FAS2552.
I created Cluster-management LIF with wrong name and wrong IP address.
How can I edit this LIF with correct informations?
Awaiting for your feedback.
2018-05-16 08:02 AM
route show -vserver cluster_name network interface show -vserver cluster_name network interface rename -vserver cluster_name -lif cluster_mgmt -newname new_cluster_mgmt_lif network interface modify -vserver cluster_name -lif new_cluster_mgmt_lif -address 10.0.0.2 -netmask 255.255.255.0 # thats the new address and mask route create -vserver cluster_name -destination 0.0.0.0/0 -gateway 10.0.0.1 -metric 20 # that the new gateway address route delete -vserver cluster_name -destination 0.0.0.0/0 -gateway 192.168.1.1 # thats the old address from route show command
i don't have a simulator here to check on. but have you tried these ?
2018-05-16 08:18 AM
i merged the two threads as i saw the duplication. and noticed you also asked about the ipspace for that interface.
i think you can't change the ipspace of the Vserver object that hosts the MGMT interfaces (the cluster_name SVM) it have to stay in the default one.
i was looking at this years back and prtty sure it was not possible. also don't see it possible here (you can't change any SVM IPSpace post creation) :
i do encourage you also to have a read on this above DOC for the ipspace typical use cases. as it's very rear for someone that is not service provider to need it and can create some pain.....