ONTAP Discussions

Fas 2240-4- add adidional DS4246 Disk Shelf

thomas382
3,460 Views

Hello;

I have a FAS 2240-4 Single Head with one DS4246, and want to add the next DS4246.

My Plan tooks like this:

1. Cabling of the ACP correct (picture i found ihe forum)

2. Cabling the SAS, connect the Controller with the new Shelf firt, then connect Shelf 3 with Shelf 2.

Is this a way to do it with no ninterruprion?

What do you recommend?

Many Thanks, Thomas

1 ACCEPTED SOLUTION

SpindleNinja
3,448 Views

Shelf adds are typically done with no disruption,  just disconnect one cable at a time. 

 

The ACP looks good in the drawing.  

 

I would add the new shelf to the end of the stack.   

View solution in original post

4 REPLIES 4

SpindleNinja
3,449 Views

Shelf adds are typically done with no disruption,  just disconnect one cable at a time. 

 

The ACP looks good in the drawing.  

 

I would add the new shelf to the end of the stack.   

lwebb
3,345 Views

Just a suggestion.  You will be doing one side at a time from the controller, after you connect one side of the new shelf, you may want to run "storage show disk -p"   to see both paths.   This can be run in the nodeshell in cmode.   After the first path is connected to the new shelf, you should see 2 paths to all disks except for the new shelve's disks.

thomas382
3,279 Views

Very good news!

Thanks a lot, i will do so tomorow evening.

Greetings, Thomas

 

thomas382
3,244 Views

Thanke, it worked fine, no problem!

Greetings, Thomas

Public