Restoring a LUN from with a Volume for 8.2.5 7-Mode
2019-04-19 08:46 AM
Have only been here a couple of months and have run into an area that I am not sure about proceeding with. Any assistance is greatly appreciated.
I have four ESXI luns, that are within a single volume, that is being snapmirrored. One of the ESXI's has gone bad and the VMware admin needs for me to re-establish one of the ESXI luns.
How can I go about restoring only the one lun from the volume that is being snapmirrored without writing over the other ther luns?
This is one of the areas that I pointed out that needed to be adjusted, but have not received approval yet. Can someone please assist with the steps for this either via CLI or OnCommand.
Thanks in advance.
2 REPLIES 2
Re: Restoring a LUN from with a Volume for 8.2.5 7-Mode
2019-04-19 09:07 AM
You should just be able to create a clone of the volume and re-map out just the lun you need.
Take this opertunity to break the lun out to it's own volume too.