Data ONTAP Discussions

Highlighted

Service Processor Ctrl+D HANG

When I login to the Service Processor it shows me below please help

 

sp reboot - reboot the SP
sp status - print SP status information
sp update - update Service Processor firmware
sp uptime - display service processor uptime

SP netappctrl2> sp status
Firmware Version: 1.2.3
Mgmt MAC Address: 00:A0:98:1A:4E:CC
Ethernet Link: Up
Using DHCP: no
IPv4 configuration:
IP Address: 10.1.5.198
Netmask: 255.255.0.0
Gateway: 10.1.1.1
IPv6 configuration: Disabled
SP netappctrl2>
SP netappctrl2> system console
Type Ctrl-D to exit.

1 REPLY 1

Re: Service Processor Ctrl+D HANG

Hi,

 

I am guessing the problem statement is - When you do ctl+D (to exit from system console) it freezes ?

 

Some pointers for your investigation.

 

SP output looks ok, but does not really help us identify the cause for 'freeze/hang'.

 

However, it is important to understand the internal connectivity of SP, this page has a pictorial representation of that.
https://library.netapp.com/ecmdocs/ECMP1155684/html/GUID-E6BBAB62-8494-4DBF-903B-A79F5E91B367.html

 

Please note : (For 7-mode FAS In general) SP & e0M both are connected to the same Internal Ethernet switch and common ethenet port. Therefore, both SP & e0M must be on the same subnet.

 

filer>ifconfig -a [Look for e0M interface , note down the IP]
e0M: IP

 

You already know the SP IP:
SP: IP

 

Question : Compare, are both on the same subnet?


Very nicely explained here by 'andris' about SP,e0M & wrench port and their requirements:
https://community.netapp.com/t5/Data-Infrastructure-Management-Software-Discussions/e0M-Management-SP-Port/td-p/18499

 

Thanks!

Try the NEW Knowledgebase!
NetApp KB Site
Forums