2018-02-16 04:21 PM - edited 2018-02-16 04:59 PM
We have been getting these event logs. Been looking at the other posts but not getting anywhere.
secd.conn.auth.failure: Vserver (xxx_svm1) could not make a connection over the network to server (ip xxx.xxx.180.80, port 445) via interface xxx.x.180.249. Error: Operation timed out.
PInging from the command using the lif that is reported to be the issue resulted Ok (is alive). Please advise before we open a case with support.
ping -vserver xxx_svm1 -lif xxx_svm1_lif06 -destination xxx.xxx.180.80
Also tried this command:
nas::> vserver services name-service dns check -vserver xxx_svm1
Vserver Name Server Status Status Details
------------- --------------- ------------ --------------------------
xxx_svm1 xxx.xxx.180.80 up Response time (msec): 4
xxx_svm1 xxx.xxx.180.81 up Response time (msec): 1
2 entries were displayed.
2018-02-19 03:39 AM
tell you the true. i suspect they didn't properly fixed:
is it happening only when the system has high load? specific interval? any actual impact?
i'm on 9.1P6 on my and i still get similar ones when i'm hammering the system (in my case high 10K IOPS of CIFS workload generated by robocopy).
2018-04-27 01:36 AM
Hello, we have same EMS log for some vserver in our cluster. that vserver have lif with home on different nodes of the cluster.
We can't see any correlation with load, but it's curious they started when we upgraded to 9.1P10.
2018-04-27 01:43 AM
this warning message could be sometime valid.
if you want to troubleshoot more - i think it's better to open a new thread and provide a bit more info/output about your configuration.
2018-04-27 02:49 AM - edited 2018-04-27 02:52 AM
Hello, I had a rapid chat with support,
they point me to this bug:
Should be fixed in 9.1P11 (9.2P3 for @SVHO)
2018-06-20 01:17 AM
We occured the same issue on Version 9.1P8. There was no connection issue or any issues related with our CIFS.
After the Update on Version 9.1P3 the EMS Events stopped and everything was fine.
Two days ago I change the DNS Servers (added two new ones, while removing the old ones).
We still do not have any issues with the connection to the DNS-Servers or the CIFS, but the messages are showing up again.
I've planed an Update on Version 9.3P5 in a few days.
I can keep you updated, if the EMS Events keep showing up after the update or if they disapear.
If they disapear the bug may still be present, but only shows if there are changes in the DNS-Settings.