Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Bookmark
- Permalink
- Email to a Friend
- Report Inappropriate Content
This is the only place it is letting me post this question. But I have an older E2600 Array. I have a cache battery that needs to replaced in one of my controllers. I need to mute the alarm. If I hit the button on the unit, it will just mute for 1 seconds and start up again. I have searched through the entire Santricity application, and the manual. It doesn't show you how to mute this thing until you get a replacement battery.
3 REPLIES 3
- Bookmark
- Permalink
- Email to a Friend
- Report Inappropriate Content
@harveypny I believe that the alarm configuration can be found on the hardware tab of the SANtricity Storage Manager application. As I recall, it can be setup on a per-controller basis. You can click to view individual hardware components, and I believe that the alarms and their settings can be found there. Unfortunately, I do not have an older system that I can verify this with right now. Let me know if you are able to locate the alarm settings based on these instructions.
Thanks,
Michael
Highlighted
- Bookmark
- Permalink
- Email to a Friend
- Report Inappropriate Content
I can list the hardware, but no where does it give me the ability to supress the beeping.
- Bookmark
- Permalink
- Email to a Friend
- Report Inappropriate Content
What would be nice, if I could tell it stop checking for the battery every 1 min. Because if you supress the alarm on the front, the next min it starts beeping again. So someone would need to press the button every minute to stop the alarm. I wish I could tell the array to check once a day or something until we replace the battery.