ONTAP Hardware

Direct conntction to Netapp FAS 8300

ashrafbinali
3,769 Views

Dear All,

we have 3 x HP DL 380 GEN 10. is it possible to connect  Netapp FAS 8300  to HP DL 380 GEN 10 ( With Out SAN Switch)

1 ACCEPTED SOLUTION

SpindleNinja
3,755 Views

Does not look like it's supported anymore.  

 

Here's the doc - https://docs.netapp.com/ontap-9/topic/com.netapp.doc.dot-cm-sanconf/SAN%20configuration.pdf

 

"You cannot directly attach FC or FC-NVMe SAN hosts to HA pairs without using a switch." - page 13 

"You cannot directly attach FC or FC-NMVE SAN hosts to single nodes without using an FC switch." - page 11 

 

 

View solution in original post

4 REPLIES 4

ashrafbinali
3,759 Views

Thank you for quick reply . I am looking for FC connectivity

SpindleNinja
3,756 Views

Does not look like it's supported anymore.  

 

Here's the doc - https://docs.netapp.com/ontap-9/topic/com.netapp.doc.dot-cm-sanconf/SAN%20configuration.pdf

 

"You cannot directly attach FC or FC-NVMe SAN hosts to HA pairs without using a switch." - page 13 

"You cannot directly attach FC or FC-NMVE SAN hosts to single nodes without using an FC switch." - page 11 

 

 

paul_stejskal
3,676 Views

Correct. Was possible in 7-mode but the functionality needed in FCP is not supported with CDOT and always has been that way. A switch is required.

 

However, if you want, as mentioned iSCSI works perfectly fine as it will be a layer 2 network anyway. Chances are, you already have it networked either way.

Public