ONTAP Hardware

FAS 2520 switchless

ANTONIO_SIMULA
3,267 Views

Hi All, i need to install a new FAS2520 C-dot 8.3.2, in our Customer.

 

The client's network infrastructure is at 1gbits, so i was thinking of configuring the cluster interfaces of each node, in the switchless mode .

 

The Fas2520 support this type of configuration ?

 

The Cluster interfaces are e0d and e0f , for each node ?

 

We need to use a crossover cable or straight-trough cable ?

 

The command for switchless mode are this :

 

set -privileges advanced

 

network options switch switchless-cluster modify -enable true

 

set -privileges admin 

 

Are the commands correct?

 

Thank you all 

 

Antonio

 

1 ACCEPTED SOLUTION

NAYABSK
3,252 Views

Hi Antonio, 

 

Thank you for contacting NetApp community, The complete information with respect to FAS 25xx installation can found in the VIDEO below.

 

FAS25XX Installation

 

FAS2520 Setup Instructions

 


The Fas2520 support this type of configuration ?

 

Yes It Supports Switchless Configuration

The Cluster interfaces are e0d and e0f , for each node ?

 

Yes 


The command for switchless mode are:

 

1. Enter the following command to enable cluster HA:

 

cluster ha modify -configured true

 

If storage failover is not already enabled, you will be prompted to confirm enabling of both storage failover and auto-giveback.

 

If you have a two-node switchless cluster, enter the following commands to verify that the switchless-cluster option is set:

 

Enter the following command to change to the advanced-privilege level:

 

set -privilege advanced

 

Confirm when prompted to continue into advanced mode. The advanced mode prompt appears (*>).

 

Enter the following command:

 

network options switchless-cluster show

 

If the output shows that the value is false, you must issue the following command:

 

network options switchless-cluster modify true

 

Enter the following command to return to the admin privilege level:

 

set -privilege admin

 

 

 

Thanks, 

Nayab

View solution in original post

2 REPLIES 2

NAYABSK
3,253 Views

Hi Antonio, 

 

Thank you for contacting NetApp community, The complete information with respect to FAS 25xx installation can found in the VIDEO below.

 

FAS25XX Installation

 

FAS2520 Setup Instructions

 


The Fas2520 support this type of configuration ?

 

Yes It Supports Switchless Configuration

The Cluster interfaces are e0d and e0f , for each node ?

 

Yes 


The command for switchless mode are:

 

1. Enter the following command to enable cluster HA:

 

cluster ha modify -configured true

 

If storage failover is not already enabled, you will be prompted to confirm enabling of both storage failover and auto-giveback.

 

If you have a two-node switchless cluster, enter the following commands to verify that the switchless-cluster option is set:

 

Enter the following command to change to the advanced-privilege level:

 

set -privilege advanced

 

Confirm when prompted to continue into advanced mode. The advanced mode prompt appears (*>).

 

Enter the following command:

 

network options switchless-cluster show

 

If the output shows that the value is false, you must issue the following command:

 

network options switchless-cluster modify true

 

Enter the following command to return to the admin privilege level:

 

set -privilege admin

 

 

 

Thanks, 

Nayab

ANTONIO_SIMULA
3,244 Views

Hi Nayab, thanks for your rapids answers .

 

Regards

Antonio

Public