Hie,
I just power on my new FAS2020A, and try to configure network properties.
So, FAS2020A had two controllers, i named it A and B.
How many IP should i have to manager my FAS ? One, Two ?
I have configured in CLI a virtual interface on the first controller A, and create a virtual interface named TRUNK-A, with IP 192.168.1.15 255.255.255.0 using e0a and e0b.
This virtual interface is up and ping successfully.
My problem, is on the second controller.
Under CLI, when i type SETUP command, and begin to configure the controller, i try to create a virtual interface, system tell me e0a and e0b are already in use ...
So i cannot had ip address on my second controller !
All my licenses are installed, and when i type CF STATUS command, it tell me CLUSTER enable.
So should i connect a wire directly from controller A to controller B ?
Actually, my two controllers had each of one two wire on two different switch with LACP enable.
So if anyone can explain me how to configure network, it will be plaisant for me.
thanks a lot.
Best regards