Flash Pool SSD on FAS3240

[kwana]

Hi,

Can FAS3240 support flash pool with 3 SSD only?

Thanks

Alex

[SEANTRACY]

My understanding is you need the same amount of SSD's on each head of a HA pair.

[aborzenkov]

No, you do not. Same as you do not need the same disk configuration

Отправлено с iPhone

28.12.2012, в 20:04, "Sean Tracy" <xdl-communities@communities.netapp.com<mailto:xdl-communities@communities.netapp.com>> написал(а):

<https://communities.netapp.com/index.jspa>

Re: Flash Pool SSD on FAS3240

created by Sean Tracy<https://communities.netapp.com/people/SEANTRACY> in Products & Solutions - View the full discussion<https://communities.netapp.com/message/97446#97446>

My understanding is you need the same amount of SSD's on each head of a HA pair.

Reply to this message by replying to this email -or- go to the message on NetApp Community<https://communities.netapp.com/message/97446#97446>

Start a new discussion in Products & Solutions by email<mailto:discussions-community-products_and_solutions@communities.netapp.com> or at NetApp Community<https://communities.netapp.com/choose-container.jspa?contentType=1&containerType=14&container=2068>

[kwana]

Thanks,

Sorry for misleading,  I mean each controller have 3 SSD disks for flash pool, can 3240 HA support this flash pool configuration
(1 data + 2 Parity)?

Alex

[SEANTRACY]

Hi, Thanks. I do have a config question. This is my first time using SSD’s NetApp setup the filer with half the SSD’s on one controller and half on the other. I am trying to figure out if I should keep all the SSD’s on one controller or spread them across two?

[SEANTRACY]

It does support it. That is the configuration I was thinking of. The SSD’s don’t need a spare as I understand it.