‎2012-06-04 05:24 AM
Hi Frndz,
In Netapp 3240, ontap 8.0.2 P7 mode we like to run a motherboard diag with the help of sldiag in maintainence mode,But in the "sldiag device show" it doesnt list the motherboard.
Is there any other command to do the motherboard diag ?
Saran
‎2012-06-04 05:36 AM
No, you have to run tests for all individual devices on motherboard. The following is currently recommended after motherboard replacement:
These devices need to be disabled: 'sas', 'fcal', 'nic', if present, 'acpm' and 'pam2/fcache'.
So you basically take default list, disable tests for above devices if present and run diagnostic.
‎2012-06-04 05:49 AM
In other FAS model, we have option to run diag seperately for motherboard right .whether is it specific about model.
‎2012-06-04 05:51 AM
Well, I do not know whether this is hardware or software specific. But this is how sldiag works.
‎2012-06-05 11:35 AM
Hi Saran,
I also found the following links that you might find helpful:
KB article 1013307: https://kb.netapp.com/support/index?page=content&id=1013307
NetApp® System Level Diagnostics Guide
Hope that helps!
Thanks,
Christine
‎2012-06-05 09:10 PM
Hi Christine,
In the below output,service processor means the motherboard right?
*> sldiag device showDEV NAME SELECTION------------- ----------- ----------interconnect ib2b disablednic e0a enablednic e0b enablednic e0c enablednic e0d enablednic e0M enabledacp acpview enabledacpm 3b.0.A enabledacpm 3b.0.B enabledacpm 3a.1.A enabledacpm 3a.1.B enabledfcal 0a enabledfcal 0b enabledfcal 0c enabledfcal 0d enabledmem mem enabledstorage 3a disabledstorage 3c disabledstorage 3b disabledstorage 3d disabledbootmedia bootmedia enabledenvironmentals environmentals enabledserviceProcessor serviceProcessor enablednvram slot2 enabled
