ONTAP Hardware

SAS & SATA

GTHOMAS13
2,989 Views

Good Day "NetAppians"

Hope you all well.

I've got an issue and hoping someone could assist.

In my enviroment: FAS2246 with 2x1TB SATA DS4243 and 1x1.2TB SAS DS2246 .

The SAS shelf is newly installed.

My question:

Can i cable all three shelves into one stack?

The FAS2246 only has two SAS port per controller so two stacks with multipathing is not possible.

Does mixing iOM3 & iOM6 in one stack have any issues on the storage?

Please any guidence will do.

Thanks

1 ACCEPTED SOLUTION

ANDREAS_ULTRA
2,989 Views

Hi,

in your case its supported to cable all in one stack. See the storage Subsystem guide for more information. Multipath is only possible to if you use a 2240HA pair.

View solution in original post

2 REPLIES 2

ANDREAS_ULTRA
2,990 Views

Hi,

in your case its supported to cable all in one stack. See the storage Subsystem guide for more information. Multipath is only possible to if you use a 2240HA pair.

sipp81
2,730 Views

i have a question.....i have two fas2040's i replaced the old drives with new sata 1tb drives one fas took the drives like a champ and has been configured and working fine, the otheer see's the drives are there but wont acknowledge the drives, can anyone give me some insight as too why this is happeneing? Thanks

Public