FAS and V-Series Storage Systems Discussions

About FAS and V-Series Storage Systems Discussions
Talk and ask questions about NetApp FAS series unified storage systems and V-Series storage virtualization controllers. Discuss with other members how to optimize these powerful data storage systems.

View By
Sort By Subscribe
Hi,   I'm running a FAS2554 (20x4TB+4xSSD) with cDOT 8.3.2P12 that was for about 2 years a SnapMirror destination and now, after moving in a new datac ...read more
Hi, Is there any limitation in FAS 2040 netapp box, running 8.0.2P3 7-Mode software, in supporting ESXi 6.7 installation in the LUN created. Thanks fo ...read more
Hello All,   My Symptom Running ontap 9.1 p13 A SnapMirror type-XDP new created relationship reports a Relationship Status of "Finalizing" without ...read more
Just trying to confirm that ADP is still only supported on the internal disks (those in the the shelf with the nodes) on the FAS26XX series running On ...read more
Hi, my FAS2554 (20x4TB+4x400SSD) is running 8.3.2P12 and works fine (I'm using only NFS as protocol).   Now I would like upgrade to 9.1P19 as suggeste ...read more
Hi;   NetApp Release 8.2.3P4 7-Mode Fully populated v3240 (600GB SAS disks), but no spares. Had to replace a few pre-fails. There's about 3 TB "availa ...read more
OpenSSH 7.4 Not Installed Multiple Vulnerabilities Device is a FAS2240-2 Version 8.2.5 7 Is this system vulnerable. Many Linux systems run an older ve ...read more
Hello, We have volumes with XDP snapmiror relationship. (ontap 9.3) when we resize the source volume we should resize also the destination volume?  al ...read more
Dear all,   I have a FAS3220 runing NetApp Release 8.2.5P1 7-Mode. Slot 2 in the controller has a QLogic card in it but the card is offline:  slot 2: ...read more
Hello; I have the problem that i cannot export a nfs share over an seperate vlan on the primary Lif(a0a 10GB, LACP Trunk), i have created a Lif(a0b 1G ...read more