FAS and V-Series Storage Systems Discussions - Page 50

Abouk

I have an issue with my HA pair configuration with FAS2220. So After shelf fault, one node 1 tookover node2 , I have theses issues : s0u1sanb(takeover)> environment shelf Environment for channel 0a Number of shelves monitored: 1enabled: yes Environmental failure on shelves on this channel? yes s0u1sanb(takeover)> sysconfig -a *** This system has taken over s0u1sana System Storage Configuration: Single-Path HA System ACP Connectivity: Partial Connectivity slot 0: SAS Host Adapter 0a (PMC-Sierra PM8001 rev. C, SAS, <UP>) slot 0: SAS Host Adapter 0b (PMC-Sierra PM8001 rev. C, SAS, <OFFLINE (hard)>) and PCM LED on, and Is there any solution for that , or I should to replace tne failed node ? Thanks alot for your advices !

IlirS

Hello, I have to replace a controller that has Ethernet ports down. Is there any replacement guide or suggestions regarding controller replacement on FAS2552 dual-controller Clustered Mode ONTAP 9.1 ? It is an old system. Is firmware update mandatory or not ? BR, Ilir

A_Zhurenkov

Hello. I want to connect FAS2720 to C9300 and trying to find supported SPF modules but I can't get access to HWU. Could someone send me this information?

Harvey_Mulenga

Hi, I'm getting error message "Disk structure is corrupt or unreadable" when trying to access a LUNs on FAS2040. What could be the problem?

SSH

Hi, We have an SAN FAS-2240 currently working with disks X422 FW NA01. We would add a disk but the FW is NA03. The disk is recognized when you add it but we didn't affect it yet. Is there any potentiel problem?

Board Activity

HA pair fas2220 troubleshooting issue

Controller replacement on FAS2552

Supported SFP modules for FAS2720

Failing to access a LUN

FAS-2240 Mix disks FW