since we have updated some of our systems (FAS82xx, AFF A300) to Ontap 9.3P7,
we see the following Errors in Messages for our (UTA2) 10GBit LAN-Ports, which have not been here before the update.
10/16/2018 11:04:14 <Filer>-<node> ALERT vifmgr.cluscheck.crcerrors: Port e0g on node <Filer>-<Node> is reporting a high number of observed hardware errors, possibly CRC errors.
ifstat shows TotalErrors (increasing) and Errors/Minute but no CRC-Errors
-- interface e0g (1 hour, 42 minutes, 32 seconds) --
RECEIVE Total frames: 56798k | Frames/second: 9233 | Total bytes: 178g Bytes/second: 28949k | Total errors: 1337 | Errors/minute: 13 Total discards: 2 | Discards/minute: 0 | Multi/broadcast: 31503 Non-primary u/c: 0 | CRC errors: 0 | Runt frames: 18 Fragment: 0 | Long frames: 1319 | Alignment errors: 0 No buffer: 2 | Pause: 0 | Jumbo: 0 Noproto: 105 | Bus overruns: 0 | LRO segments: 50798k LRO bytes: 174g | LRO6 segments: 0 | LRO6 bytes: 0 Bad UDP cksum: 0 | Bad UDP6 cksum: 0 | Bad TCP cksum: 0 Bad TCP6 cksum: 0 | Mcast v6 solicit: 0 TRANSMIT Total frames: 16298k | Frames/second: 2649 | Total bytes: 11749m Bytes/second: 1909k | Total errors: 0 | Errors/minute: 0 Multi/broadcast: 605 | Pause: 0 | Jumbo: 6655k Cfg Up to Downs: 0 | TSO non-TCP drop: 0 | Split hdr drop: 0 Timeout: 0 | TSO segments: 840k | TSO bytes: 9910m TSO6 segments: 0 | TSO6 bytes: 0 | HW UDP cksums: 0 HW UDP6 cksums: 0 | HW TCP cksums: 0 | HW TCP6 cksums: 0 Mcast v6 solicit: 0 DEVICE Mcast addresses: 4 | Rx MBuf Sz: 4096 LINK INFO Speed: 10000m | Duplex: full | Flowcontrol: none Media state: active | Up to downs: 2
From my feeling it looks like a BUG in Data Ontap 9.3P7 (Error in their Portstats, ...), as we dont find any matching Errors in our Network infrastructure. Also no impact seen to the systems.
I already opened a support Case, but uptonow they cannot match this to an existing BUG, as 9.3P7 should have fixed all issues regarding this problem.
So timeconsuming debugging on customer site must be done to find the root-cause 😞
So the Question to the community: Anybody seen this Errors on Ontap 9.3P7?
... View more
Hello We have FAS 2720 box with Base T ports, i would like to use Base T e0c/e0d/eoe/e0f ports for cluster interconnect , to use e0a/e0b SFP+ ports for data traffic. I see this is supported config on HWU, however during cluster setup creation it doesnt create cluster interface lif's and unbale to join the second nodes to switchless cluster thanks Ragesh
... View more