I'm in the infancy of powershell, i've managed to write 1 script so far that was pretty basic. However i've recently started down the route of trying to get a basic check in place. The check would be run via a script and would show if the nodes are up.
I cannot find a cmdlet of anything in get-ncnode or get-ncnodeinfo that would provide me with this as a starter.
Again, I may have missed this due to lack of knowledge but a nudge in the right direction would be greatly appreciated.
What we monitor is the figures above increasing to ensure data is going through each node- we do this as we once had a situation where the nodes where up but no data was being sent or recieved - kind of a big problem! So I want to automate this but i'm really struggling with the powershell equivalent of the above.