No - at cutover we changed the existing CIFS Server on 7-mode to a temporary name, then ran CIFS Setup on the SVM and used the original CIFS Server name then ran cutover. Strange sequence but it worked mutiple times. I wondered if it was right myself! Documentation was very incomplete. Thankfully I had a test system and some resources to ask and was able to figure it out.
Actually we pre-created a DNS entry for the temporary CIFS Server name.Right before we clicked Apply Configuration and Complete Transition in 7MTT, we did this:
On the 7-mode source system, terminate CIFS, re-run CIFS Setup and rename the CIFS Server with the temporary name.
On the cdot destination system, create the CIFS Server with the original name. It is using a temporary LIF we added to the SVM.
After finishing the 7MTT process, we then stopped the 7-mode CIFS Server completely which allowed us to re-use the original IP. We added the original IP to the SVM on cdot and removed the temporary one. I hope that helps!
Hello guys, I'm new on migration and still learning. I don't understand how do you migrate the data previous to configure the cifs vserver on the cdot. How do you configure the vserver destination? That's not clear for me.
This is the workflow that has worked for us and we have been using this sequence to successfully transition 7-mode vFilers with CIFS volumes to clustered ONTAP.
1. Close open files and sessions on the CIFS share. 2. Write down the CIFS share configuration and current sessions on 7-mode. 3. Gracefully terminate CIFS service on the vFiler. Note: it is not a requirement to disconnect CIFS shares from client end. The best practice is to discontinue connectivity from storage side. However, if there will be any IP or share name/path changes, shares must be disconnected from client end as well and re-connected after cutover. 4. Assign a temporary CIFS server name on the vFiler and update DNS. Re-run CIFS setup on the vFiler in order to reconfigure the CIFS server to use a temporary name. Update DNS to point the IP to this temporary name. Remove the AD computer account for the original CIFS server identity. A new AD computer account with the temporary identity will be automatically created during CIFS setup. Note: CIFS service should be running with the new temporary identity because it is required to read CIFS configurations from the vFiler during pre-cutover phase. 5. Configure CIFS on the SVM with the original 7-mode identity ("vserver cifs modify" command for ONTAP 9.0 or later). Create an AD computer account for the original CIFS identity and verify CIFS server is now running with this identity. 6. Apply configuration and move project to Precutover phase. Note: Ensure that CIFS server is running on the source vFiler and the target SVM! 7. Perform cutover. 8. Update DNS and AD computer account. Update DNS to point the CIFS IP to the original CIFS identity. Remove the temporary AD computer account which was automatically created during vFiler CIFS setup along with the temp CIFS server which was initially configured on the SVM. 9. Perform cleanup tasks. - verify CIFS lif is up on the SVM - remove the CIFS lif which has been initially configured on the SVM so that it could be temporarily joined to the AD domain - verify volume is online and writable, and shares are visible - verify CIFS export policy and rule are applied on the SVM - verify volume is junctioned into the SVM namespace Note: if volume was transitioned with its 7-mode path, unmount the volume from /vol directory and mount it into the SVM namespace (/). - delete vserver peer transition relationship - update the ls-mirrors for the SVM root volume 10. Ensure CIFS shares are accessible from client end. Connect shares with the new path along with all prefixes (if /vol direstory has been removed). Ensure write operations are successful.