Network Storage Protocols Discussions

Enabled/Disabled virtual interface?

bmccullough

I have two FAS3140 running NetApp Release 7.3.1.1.  I am able to ping the IP addres of the first FAS but not the second FAS.  The second FAS is reporting they virtual interface as disabled!?!

I can ping out of the second FAS to other devices but not the reverse.

Help and thanks.

fas03> cf status
Cluster enabled, fas04 is up.

fas04> cf status
Cluster enabled, fas03 is up.

cat /mnt/fas03/etc/rc
hostname fas03
vif create lacp lvif1 -b ip e0a e0b e4a
vif create lacp lvif2 -b ip e4b e4c e4d
vif create single svif lvif1 lvif2
vlan create svif 340 348 351
ifconfig svif-340 `hostname`-svif-340 netmask 255.255.255.0 partner svif-340
ifconfig svif-348 `hostname`-svif-348 netmask 255.255.255.128 partner svif-348
ifconfig svif-351 `hostname`-svif-351 netmask 255.255.255.128 partner svif-351
ifconfig e0M `hostname`-e0M flowcontrol full netmask 255.255.255.0 partner e0M
route add default 10.13.240.1 1
route add net 10.13.244/24 10.13.244.1 1
routed on
options dns.enable off
options nis.enable off
savecore

fas03> ifconfig svif-340
svif-340: flags=948043<UP,BROADCAST,RUNNING,MULTICAST,TCPCKSUM> mtu 1500
        inet 10.13.240.23 netmask 0xffffff00 broadcast 10.13.240.255
        partner svif-340 (not in use)
        ether 02:a0:98:0d:d1:a9 (Enabled virtual interface)

cat /mnt/fas04/etc/rc
hostname fas04
vif create lacp lvif1 -b ip e0a e0b e4a
vif create lacp lvif2 -b ip e4b e4c e4d
vif create single svif lvif1 lvif2
vlan create svif 340 348 351
ifconfig svif-340 `hostname`-svif-340 netmask 255.255.255.0 partner svif-340
ifconfig svif-348 `hostname`-svif-348 netmask 255.255.255.128 partner svif-348
ifconfig svif-351 `hostname`-svif-351 netmask 255.255.255.128 partner svif-351
ifconfig e0M `hostname`-e0M flowcontrol full netmask 255.255.255.0 partner e0M
route add default 10.13.240.1 1
route add net 10.13.244/24 10.13.244.1 1
routed on
options dns.enable off
options nis.enable off
savecore

fas04> ifconfig svif-340
svif-340: flags=148043<UP,BROADCAST,RUNNING,MULTICAST,TCPCKSUM> mtu 1500
        inet 10.13.240.24 netmask 0xffffff00 broadcast 10.13.240.255
        partner svif-340 (not in use)
        ether 02:a0:98:0d:d1:d1 (Disabled virtual interface)

2 REPLIES 2

bmccullough

Ok the sub-vitrual interface is not correct, getting closer...

fas04> vif status lvif2
default: transmit 'IP Load balancing', VIF Type 'multi_mode', fail 'log'

lvif2: 0 links, transmit 'IP Load balancing', VIF Type 'lacp' fail 'default'
        VIF Status     Addr_set

(         VIF Status     Up      Addr_set             <-----      funtional entry would be )

        trunked: svif
        lag_inactive:

(        up:                                                    <----- funtional entry would be )

        e4b: state lag_inactive, since 17Nov2009 01:50:29 (6+19:21:34)
                mediatype: auto-1000t-fd-up
                flags: lacp enabled
                input packets 0, input bytes 0
                input lacp packets 0, output lacp packets 588654
                output packets 588653, output bytes 72992972
                up indications 1, broken indications 0
                drops (if) 0, drops (link) 0
                indication: lag_inactive at 17Nov2009 01:50:29
                        consecutive 0, transitions 1
        e4c: state lag_inactive, since 17Nov2009 01:50:29 (6+19:21:34)
                mediatype: auto-1000t-fd-up
                flags: lacp enabled
                input packets 0, input bytes 0
                input lacp packets 0, output lacp packets 588654
                output packets 588653, output bytes 72992972
                up indications 1, broken indications 0
                drops (if) 0, drops (link) 0
                indication: lag_inactive at 17Nov2009 01:50:29
                        consecutive 0, transitions 1
        e4d: state lag_inactive, since 17Nov2009 01:50:29 (6+19:21:34)
                mediatype: auto-1000t-fd-up
                flags: lacp enabled
                input packets 0, input bytes 0
                input lacp packets 0, output lacp packets 588654
                output packets 588653, output bytes 72992972
                up indications 1, broken indications 0
                drops (if) 0, drops (link) 0
                indication: lag_inactive at 17Nov2009 01:50:29
                        consecutive 0, transitions 1

bmccullough

Fixed.  The issue was with the network settings on the cisco switches they FAS was plugged into.

Was:

interface GigabitEthernet1/25                                          
channel-protocol lacp                                                 
channel-group 4 mode active                                           
!                                                                      
interface GigabitEthernet1/26                                          
channel-protocol lacp                                                 
channel-group 4 mode active                                           
!                                                                      
interface GigabitEthernet1/27                                          
channel-protocol lacp                                                 
channel-group 4 mode active                                           
!                                              

should of been;

interface GigabitEthernet1/25                                           
switchport trunk encapsulation dot1q                                  
switchport trunk allowed vlan 340,344,348,351                         
switchport mode trunk                                                 
channel-protocol lacp                                                 
channel-group 4 mode active                                           
!                                                                      
interface GigabitEthernet1/26                                          
switchport trunk encapsulation dot1q                                  
switchport trunk allowed vlan 340,344,348,351                         
switchport mode trunk                                                 
channel-protocol lacp                                                 
channel-group 4 mode active                                           
!                                                                      
interface GigabitEthernet1/27                                          
switchport trunk encapsulation dot1q                                  
switchport trunk allowed vlan 340,344,348,351                         
switchport mode trunk                                                 
channel-protocol lacp                                                 
channel-group 4 mode active                                           
!

Announcements
NetApp on Discord Image

We're on Discord, are you?

Live Chat, Watch Parties, and More!

Explore Banner

Meet Explore, NetApp’s digital sales platform

Engage digitally throughout the sales process, from product discovery to configuration, and handle all your post-purchase needs.

NetApp Insights to Action
I2A Banner
Public