Hello,
I'm very new to NetApp and have very limited knowledge, so go easy.
Basically I am trying to re-IP the second head of our FAS2040. The first head ran setup fine, however head two gets stuck in some kind of loop that I can't seem to break.
I've been looking around and I can see that there is a command to factory reset the filer but I can't get to the CLI to be able to do this. (I am using a console cable).
I've also tried doing things from the partner by using cf takeover -f but certain commands cannot be invoked in takeover
I do get some kind of error saying that it can't write to /etc/hosts.new
Anyone have any ideas??
Thanks Joe