Dear Community Members,
I have an issue with my vFiler network configuration.
I have 3 ipspaces:
default-ipspace | (c0a c0b e0M losk VIF VIF-10 VIF-6) |
VIF-1210 | (VIF-1210) |
VIF-1215 | (VIF-1215) |
I have 3 vFilers:
Vfiler Name
| vFiler IPSpace
| vfiler IP
|
---|
vfiler01 | VIF-1210 | 10.254.0.96 |
vfiler02 | VIF-1210 | 10.254.0.97 |
vfiler03 | VIF-1215 | 10.128.0.100 |
my RC file:
ifgrp create lacp vif01_1GB -b ip e0a e0b
ifgrp create lacp vif02_10GB -b ip e6a e6b
ifgrp create single VIF vif01_1GB vif02_10GB
ifgrp favor vif02_10GB
vlan create VIF 10 6
vlan add VIF 1215 1210
ifconfig VIF-1215 partner VIF-1215
ifconfig VIF-1210 partner VIF-1210
ifconfig VIF-1215 vfiler03 netmask 255.255.255.0
ifconfig VIF-1210 vfiler01 netmask 255.255.255.0
vfiler run fridafs02 setup -e VIF-1210:10.254.0.97:255.255.255.0 > < This line permit to have 2 vFiler in the same VLAN and replace the line ifconfig VIF-1210 vfiler02 netmask 255.255.255.0
vfiler run fridafs01 route add default 10.254.0.254 1
vfiler run fridafs02 route add default 10.254.0.254 1
vfiler run fridafs03 route add default 10.128.0.254 1
I ping my three vfilers the 3 are reachable
I restart my controler
During the reboot no response from vfiler (Normal)
after the reboot
vfiler01 & vfiler03 are reachable but vfiler02 is not reachable until i run the orange line.
My question how integrate the orange line in the rc.
Regards.