Data Backup and Recovery

SnapCenter Backups - Spanning Resources

nicholsongc
2,106 Views

I'm using VMDKs from multiple datastores/LUNs/Volumes to create a spanned Windows NTFS volume in a VMware VM.

 

So machine ServerA has two (2) disks connected - each hosted on separate data stores from different volumes

Disk1 [Datastore01\ServerA.vmdk] 100GB

Disk2 [Datastore02\ServerA.vmdk] 100GB

These disks are spanned to create a single "F:" drive of 200GB

 

Datastore01 is from the path /vol/Volume01/Lun01

Datastore02 is from the path /vol/Volume02/Lun01

 

I create a resource group in SnapCenter to backup the VM and include ALL spanned entities

 

The backup runs and I now have two snapshots.... one on each of the volumes

 

Volume01 - ServerA_test_12-13-2018_13.36.47.9187

Volume02 - ServerA_test_12-13-2018_13.36.47.9187

 

Judging by the identical snapshot names, it appears both volumes were quiesced for snapshots simultaneously to ensure a consistent snap - thus allowing for a supported method for restoring files from a spanned drive.

 

I haven't found specific wording in the SnapCenter or other documentation ...so I was hoping that one of my fellow community members could either confirm or refute this practice.

 

 

 

1 ACCEPTED SOLUTION

SYNTAXERROR
2,030 Views

Snapshot is on a per Volume basis so you have one Snapshot on each Volume.

Is VM consistent Snapshot enabled and required?

If yes, the VMWare Snapshot is made consistent on both disk so it is consistent over both volumes.

View solution in original post

1 REPLY 1

SYNTAXERROR
2,031 Views

Snapshot is on a per Volume basis so you have one Snapshot on each Volume.

Is VM consistent Snapshot enabled and required?

If yes, the VMWare Snapshot is made consistent on both disk so it is consistent over both volumes.

Public