Network and Storage Protocols

[netif.linkErrors:warning]: Excessive link errors on network interface e0a.

S_AJAY1988

Hi,

We are getting the below error on the SAN controller after the motherboard on the filer was replaced recently. What could be the reason for this error and how to rectify the same?

Note: All the physical connections to the Filer are cross verified and confirmed to be correct.

Error message for your reference

[: netif.linkErrors:warning]: Excessive link errors on network interface e0a.Might indicate a bad cable, switch port, or NIC, or that a cable connector is not fully inserted in a socket. On a 10/100 port, might indicate a duplex mismatch

1 REPLY 1

pascalduk

I would start with replacing the cable and/or try a different switch port. If that does not help, I would contact netapp support since it probably is a filer issue.

Announcements
Register for Insight 2021 Digital

INSIGHT 2021 Digital: Meet the Specialists 2

On October 20-22, gear up for a fully digital, totally immersive virtual experience with a downright legendary lineup of world-renowned specialists. Tune in for visionary conversations, solution deep dives, technical sessions and more.

NetApp on Discord Image

We're on Discord, are you?

Live Chat, Watch Parties, and More!

Explore Banner

Meet Explore, NetApp’s digital sales platform

Engage digitally throughout the sales process, from product discovery to configuration, and handle all your post-purchase needs.

NetApp Insights to Action
I2A Banner
Public