we have 2 cifs shares on vserver Both were working till date but since yesterday only one of the paths connect at one time with the respective credentials. we are getting below , if we try to connect to other share Error : The network Folder Specified is currently mapped using a different username and password To connect using a different user name and password, first disconnect existing mapping to this network drive The issue may be due to trying to connect to the same server with different credentials, both share1 & share 2 paths were working till yesterday the issue occurred today. Kindly help resolve the same as it will impact our scheduler. I am suspecting that earlier the one CIFS share was connecting through IP1 and Other CIFS share was connecting through IP2 or vice versa. Thus allowing both shares to connect from same source server. Currently the connection is going to the same IP either IP1 or IP2 I have tested the scenario through and it worked when I connected one of them with IP1 and other with IP2 via respective service accounts Please advise on the fix since as per norms, we should not use the Ip addresses directly. The naming convention should be used. Please advise.
... View more
Greetings to All, Trying to configure the S3 protocol in NetApp AFFC250 Version 9.12.1P1. Got the below error message. An eligible broadcast domain was not found, and the network interface could not be added. Validated the list of IPs from the both cluster node 1 and node 2 (e0c and e0d) through the cmd - broadcast-domain show and network port show Node 1 cluster is up and healthy @ e0c and e0d Node 2 cluster is up and healthy @e0c and e0d Used the Network port IP's of Node 1 e0c and Node 2 e0c while creating SVM got the above mentioned error. Tried with e0d pair aswell. Unable to fix the error, Appreciate if anyone could share their experience and knowledge that can resolve this error. Thankyou.
... View more
Need to setup MFA for NetApp SSH, have found it can be done using Yubikeys and all. Considering tight security and client requirements, is there a way to setup SSH from Azure Directory services (Similar to SAML).
... View more
We are using SnapDiff for our NetApp NAS backups. the snapdiff got disabled after we upgraded our OnTap to 9.10. After talked to NetApp, we have to manually enabled it. But NetApp confirmed the SnapDiff is going to be discontinued on version 9.18. Not sure why NetApp is doing this. Any replacement feature for Snapdiff after 9.18? We are using Rubrik CDM to back up our NAS data, some CIFS shares are really big and have multi million small files. Without the SnapDiff, the meta data scan is going to take a few hours to get the difference between two backups, it caused our NetApp slow down and user complains the access. we are worrying about these backups after version 9.18 when we don't have the snapdiff anymore. Appreciated if someone has same concerns and has any plan to fix the situation. thanks,
... View more
