Hi there I am starting from scratch to install a FAS2040 is there a setup guide any where I am not finding one
also any help would be appreciated.
Try a few of these:
https://library.netapp.com/ecm/ecm_download_file/ECMM1280349
https://community.netapp.com/t5/FAS-and-V-Series-Storage-Systems-Discussions/Initial-configuration-FAS2040/td-p/77125
https://www.sysadmintutorials.com/tutorials/netapp/netapp-data-ontap-7-mode/netapp-basic-setup/
Thanks I'll check it out
so I set the IP and subnet etc but the device is still showing something else
is there a way to force the new config
You could boot into maintenance mode (ctrl-c) during boot. and do opt 4 on each controller that will wipe everything, including any data.
Got it going, looking to do link aggregation ports so 2 ports work together
in this case both e0a I’d like to get together
hey buddy do you know if FAS2040 8.0.2 will support this
https://docs.netapp.com/ontap-9/index.jsp?topic=%2Fcom.netapp.doc.exp-multp-cg%2FGUID-22C99AFB-C64C-4E99-8DD0-8F705BC803F8.html
Which part? the modify ACLs?
ok here is whats happening trying to get backuppc 4.3.2 to write to the san
and its failing due to permissions I feeling like
backuppc is running, I can send a request to start a full backup
bu then fails right away the logs are not helpful
my fas2040 is 8.0.2 node 7
nfs 3,4 is enabled
the mount point is up
its just not writing to the share in the mount point
